![]() When you add wire numbers at the top or bottom, Promise puts them were the end of the wire was before it was stretched. If you stop at another wire, it doesn't joint them. Stretching wires by draging the end with the mouse doesn't work. Commands such as Place Symbol Again cause problems with Undo. Sometimes it undoes a lot of steps and often when it does this the Redo command is greyed out. You have to manually change the alignment on every top and bottom wire number to produce a decent looking drawing. All the functions below are in the manual, they just don't work the way they should.īasic things like wire numbers at the top and bottom of wires having the wrong alignment so they crash into symbols. I am using Bentley Powerdraft Promis-e V8i. Even with Bentley taking them over it is still BUG CITY.
0 Comments
Leave a Reply. |